Tile Repair

Tile Repair

Loose and Hollow Tile Refixing

Lifting and rebedding tiles that rock, sound hollow or have lifted, after finding and fixing the cause.

Free Tile Repair quote

No obligation. We only use your details to reply about this job.

Loose and Hollow Tile Refixing — Tile Repair

What's involved

Hollow-sounding tiles usually have poor adhesive coverage underneath, often from dot-and-dab fixing, which leaves voids that eventually crack the tile. Loose tiles can also signal movement in the floor or water behind wall tiles. The tiler taps the area to map hollow tiles, then carefully lifts them, cleans the back and the substrate, and rebeds with a solid bed of flexible adhesive. On timber floors that flex, extra screws in the boards or overboarding with tile backer may be needed. Where tiles have risen in a tented ridge, usually from expansion with no movement joint, a perimeter or field movement joint is added. Refixing a few tiles takes one to two hours. You need to say if any tiles have been loose for long, as water may have soaked the substrate.

How we handle it

  1. Send photos

    Use the quote form to tell us what is damaged, the tile type, wall or floor, and whether you have spares. Close-up and wider photos help the tiler assess the job.

  2. Check and price

    A local tiler reviews the photos or visits to check for hollow tiles, movement or leaks, and gives you a fixed price for the repair.

  3. Source matching tiles

    If you have no spares, the tiler helps source matching or close tiles, or recommends chip repair instead of replacement.

  4. Repair

    Damaged tiles are cut out and replaced, chips filled, loose tiles rebedded, grout replaced or seals renewed, with neighbouring tiles protected throughout.

  5. Grout, seal and hand over

    Joints are grouted to match, stone is sealed and the area cleaned. The tiler tells you when the floor or shower can be used again.

Price guide

Tile repair prices depend on how many tiles are affected, the tile type and whether the cause needs fixing as well. Replacing one or two tiles is a short job, while regrouting a bathroom takes a day. We provide a fixed price after photos or a short visit, including materials and grout.

  • Bath or shower reseal: £80–£160. Removing old silicone, treating mould and applying new sanitary-grade sealant.
  • Regrout bathroom walls: £300–£700. Raking out and regrouting a typical bathroom or shower enclosure in a day.
  • Refix loose or hollow tiles: £120–£350. Lifting and rebedding a small area with flexible adhesive, depending on extent.

Questions about loose and hollow tile refixing

Why do tiles sound hollow?

Tiles sound hollow when there are voids in the adhesive underneath, often because they were fixed with dots of adhesive rather than a solid bed. Hollow tiles are more likely to crack under load. If only a few sound hollow and are not cracked, they may be left, but loose or cracked ones should be rebedded.

Can loose wall tiles mean a leak?

Yes. Loose or bulging tiles in a shower are often a sign that water has got behind them through failed grout or silicone and softened the plasterboard or adhesive. The tiler checks the wall behind; if it is damp or crumbling, the area must be dried or the board replaced before retiling.

Get a free tile repair quote

Tell us what you need and we'll come back with a clear price.

Request a quote